Helmholtz Synthesizer

Koenig Acoustical · Physics

Accession Number: 2015.ph.699

Instrument Name: Helmholtz Synthesizer

Description:

The object consists of a large flat wooden base on which rests ten tuning fork and resonator units connected to a ten-key keyboard. The keyboard has ten ivory plated wooden keys each attached to a string that leads to one of the ten resonator units. Pressing a key causes the string to be pulled, releasing the covering over the resonator opening.

Each resonator unit consists of a flat wooden base of its own holding a steel tuning fork, a brass cylindrical resonator held by a brass stand (the largest resonator is held by two brass stands) on an adjustable wooden base attached to the unit base. A black coated metal paddle covers the opening to the resonator, held in place by a steel spring that causes it to return to its original position covering the resonator opening once the key holding its attached string is released. On either side of the tuning fork are two vertical black-coated metal bars each holding a coil of copper wire with an extended steel piece extending to the bars of the tuning fork. When current is run through the coils, the tuning fork vibrates. These proximity of these black metal bars (and attendant coils and steel pieces) can be adjusted at the base via brass knobs. At the base are two contact points holding the copper wire that runs into the coils.

The copper wire extends through each of the ten units and connects to two nodes on the main wooden base to which current can be added to the instrument. Each resonator unit has an additional small brass handle that has an unknown, but possible dampening effect on the resonator. Each unit also has a label of the unit number (1 through 10) and the resonance/note played by the tuning fork.

Primary Materials: Wood, Brass, Steel.

Dimensions (cm):

Height = 40cm, Length = 106, Width = 59.

Function:

The synthesize of vowels using Helmholtz resonators.

Condition:

Excellent. The object shows few signs of use or wear or tear. Some of its strings have been replaced.

Associated Instruments: Mercury-based Interrupter (2015.ph.714)

Manufacturer: Rudolf Koenig, Paris

Date of Manufacture: 1880s

Provenance:

Department of Physics, University of Toronto. This object was purchased by James Loudon, professor of Physics, in the 1870s or 1880s. It was used largely for demonstration.

Donated to UTSIC: No